Free JN0-363 Practice Test Questions | Know You're Ready for Service Provider Routing and Switching, Specialist (JNCIS-SP)

Which two statements are correct about the way that BGP propagates routes by default? (Choose two.)

A. A route learned by EBGP will be re-advertised to IBGP peers.

B. A route learned by IBGP will not be re-advertised lo IBGP peers.

C. A route learned by EBGP will not be re-advertised to IBGP peers.

D. A route learned by IBGP will be re-advertised to IBGP peers.

What is the correct order of BGP attributes for active route selection?

A. next hop –> local preference –> AS path –> MED –> origin

B. next hop –> local preference –> AS path –> origin –> MED

C. next hop –> origin –> local preference –> AS path –> MED

D. next hop –> AS path –> local preference –> origin –> MED

Which BGP attribute is used to detect routing loops?

A. AS path

B. MED

C. local preference

D. next hop

Which two statements are correct about BGP? (Choose two.)

A. IBGP neighbors must use the same AS number.

B. By default, the TTL on product-related packets for external neighbors is set to 1.

C. EBGP neighbors must use the same AS number.

D. By default, the TTL on protocol-related packets for internal neighbors is set to 1.

You are implementing traffic engineering in your MPLS network. You must ensure that the MPLS routes are used to traverse your network. Your solution should not affect IGP routes in your route tables. In this scenario, which traffic engineering setting will accomplish this behavior?

A. bgp-igp-both-ribs

B. mpls-forwarding

C. bgp-igp

D. bgp

Which statement is true about the BGP active state?

A. The BGP active state is the initial state where all BGP traffic is refused.

B. The BGP active state is when BGP attempts to acquire a peer by initiating a TCP connection.

C. The BGP active state is when BGP waits for the TCP connection to be established.

D. The BGP active state is when BGP exchanges update, notification, and keepalive messages with its peer.

Exhibit<br><br>

A. R2 will perform a lookup using the mpls.0 table.

B. R1 will perform a lookup using the lnet.3 table.

C. R1 will perform a lookup using the mpls.0 table.

D. R2 will perform a lookup using the inet.3 table.

You want to enable a routing platform with redundant REs to switch from a primary RE to a backup RE without alerting peer nodes. Which two technologies would you use to satisfy this requirement? (Choose two.)

A. GRES

B. VRRP

C. NSR

D. ISSU