Free JN0-363 Practice Test Questions | Know You're Ready for Service Provider Routing and Switching, Specialist (JNCIS-SP)

Which two statements ate correct about the BGP next-hop attribute value? (Choose two.)

A. By default, the next-hop value is changed across IBGP links.

B. By default, the next-hop value is changed across EBGP links.

C. By default, the next-hop value is not changed across IBGP links.

D. By default, the next-hop value is not changed across EBGP links.

Interface ge-0/0/0.0 connects you network to your ISP. You want to advertise this interface address as an Internal route In OSPF without creating a neighbor with your ISP. In this scenario, how is this task accomplished?

A. Remove interface ge-0/0/0.0 from OSPF.

B. Create a generated route for Interface ge-0/0/0.0.

C. Add ge-0/0/0.0 as a passive interface In OSPF.

D. Configure a static route for Interface ge-0/0/0.0.

Which statement describes integrated routing and bridging (IRB) interfaces?

A. An IRB interface Is an IP gateway For hosts of a bridge domain.

B. An IRB interface assigns interfaces to VLANs.

C. An IRB interface enables Layer 2 switching on the router.

D. An IRB interface defines a bridge domain.

Which two steps are required to enable MPLS on a physical interface in Junos? (Choose two.)

A. Add family mpls on the interface.

B. Add the loopback interface under protocols mpls.

C. Add family mpls on the loopback interface.

D. Add the interface under protocols mpls.

You are deploying link aggregation groups. By default, what are two considerations in this scenario? (Choose two.)

A. There should only be four member links per LAG.

B. All the ports must have the same speed.

C. Member links are required to be contiguous ports.

D. Member links can reside on different members within an MC-LAG.

You are troubleshooting two OSPF routers that have an adjacency that remains in the ExStart state. What would cause this problem?

A. mismatched OSPF hello intervals on the OSPF interfaces

B. mismatched authentication settings on the OSPF interfaces

C. mismatched MTU settings on the OSPF interfaces

D. mismatched subnet settings on the OSPF interfaces

Which LSA type does an OSPF ABR use to advertise external routes generated by an NSSAASBR into the backbone?

A. Type 5

B. Type 7

C. Type 3

D. Type 1

You are asked to create connections between routing instances on the same Junos device and route between the connected Instances. What are two ways to accomplish this task? (Choose two.)

A. Use physical interfaces.

B. Use an IRB interface.

C. Use logical tunnel interfaces.

D. Use loopback interfaces.